Step 1: Because we are working with your car's electrical system, it is advisable to disconnect your battery while installing your new headlights.
Step 2: Using an 8mm socket, remove the 3 bolts on the top of the front fascia and the 2 bolts holding on each headlight housing.
Step 3: Carefully pull your headlight out the front far enough so that you have access to the wire harness and the bulb. You'll need to pull the front fascia forward carefully to get the headlight loose. (This may be covered in more detail in your owners manual under the section for changing your headlights)
Step 4: Remove the stock bulb by twisting off the plastic securing ring on the back of the headlight and pulling the bulb out. Put the HID bulb into position and secure it using the plastic securing ring.
Step 5: Connect the 2 power leads from the XTec kit to the stock wire harness as shown. You are putting the black wire into the spot with the black wire and the red wire into the spot with the purple wire like so..
Step 6: Find a suitable spot in your engine bay and mount the ballast using the supplied double sided tape and/or wire ties.
Step 7: Connect the power wire harness to the ballast in the obvious position.
Step 8: Connect the HID bulb to the ballast using the obvious connectors.
Step 9: Reinstall the headlight. Repeat these steps on the other side, reconnect your battery and...
